Krick ANTARES Mode D'emploi page 67

Note at this point that the superstructure
should already be decorated with mahogany
parts, contrary to the image.
Cut into the backrest at the transitions to the
superstructure and wheelhouse up to the seat
board and remove the excess.
After the superstructure has been equipped
with veneer parts 79 to 81, the benches can be
stuck on.
Now attach the edging made of bent bars 116
on the backrests on the top and bottom of the
deck. The edging at the bottom of the super-
structure is made with Sapelly strips part 106.
Contrary to the image, the window frames on
the superstructure can be found on the brass
etched parts board.
Updated June 2016
Now the edge on the superstructure roof can
also be sanded into shape.
Next, you can smooth and paint the roof.
Now would also be the right time to apply a
primer coat and paint to the deck.
9. Mast and booms
First put together the lower cap, which is com-
prised of parts 128 and 129.
129
Level off the sides of the mast 126 at the top
and taper so that the cap can be slid over it.
128
Page 19
128
129
130
©
Krick Modelltechnik Knittlingen