Publicité
Les langues disponibles
Les langues disponibles
boards can be stuck across the entire length
using super glue.
Next, place the deck parts 2 on the support
boards and mark the position of the servo
board part 37 in the hull under the cabin cut-
out.
Now clip the support boards 38 and 39 on the
servo board and align it 5 cm below the sup-
port boards.
If the position is correct, the support bars can
be affixed in the hull, without sticking together
the servo board. Afterwards, remove the servo
board and stick the support boards in the hull.
In a final step, the hull reinforcements for the
chain plates are stuck into the hull.
Glue the reinforcement parts 220, 221 and 222
layer by layer one after another with 5 min
Updated June 2016
epoxy flat in the hull so that the plywood
adapts to the shape of the hull.
7. The deck
To build the deck, you will need an even build-
ing board of approx. 115 cm x 30 cm.
Cover the building board with household foil so
that the deck can be glued on top and will not
stick.
Attach the halves of the deck 2 on the holes
provided to glue onto the building board. This
will mean that the deck lies flat and cannot
5 cm
warp when the glue dries. To glue wooden
parts, for best results, use waterproof wood
glue.
Drill a 4 mm hole 412 mm from the bow for the
mast bearing to be attached later.
Next, glue the bulkheads 3-10 into the re-
cesses in the deck.
Page 8
©
Krick Modelltechnik Knittlingen
Publicité
