Publicité
Les langues disponibles
Les langues disponibles
Bulkhead 7 is doubled.
Glue parts 17, 18 and 19 onto the block.
Then stick parts 17, 18 and 19 and the frame
11-15 onto the deck.
Next, glue the fill block 16 in the stern and
adapt it to the contours of the hull.
Coaming
Updated June 2016
Next, attach the base layers to separate the
upper deck. Sand part 29 sharp at the front
edge so that the reinforcement correctly and
flat on the outer edge of the deck.
The base layers are to be stuck onto the bulk-
heads so that the interlocking area of the upper
deck 20 is supported optimally.
Now the coamings parts 21 to 28 of the deck
openings are stuck in. First, stick in the coam-
ing of the skylight parts 24 to 25 and the
wheelhouse parts 21 to 23. To do so, remove
the fastening straps on the lower deck at these
points. Allow the rest of the fastening straps to
stay where they are so that the deck remains
fastened to the building board. The coaming of
the skylight and the walls of the cabins are
installed later, after removing the deck from the
building board. Installing the two coamings
should make it easier to align the upper deck.
Next glue on both halves of the upper deck.
To do so, leave the deck on the building board
so that the deck cannot warp when the glue is
drying. Before glueing, you should check the
exact fit of the two parts and adjust it accord-
ingly so that the transition of the two parts of
the deck is as hard to see as possible.
16
When glueing, make sure that no glue gets
onto the top side of the deck. If this does hap-
pen, wipe it off with water immediately. If glue
dries on the top surface, there is a risk that it
Page 9
29
©
Krick Modelltechnik Knittlingen
Publicité
