Publicité
Les langues disponibles
Les langues disponibles
will not be possible to stain that area or there
will be flecks when painting.
Next, glue on the coaming for the front com-
panionway parts 26 to 28.
Following this, remove the bulkhead 5 on the
right and left of the cut-out of the subsequent
cockpit and sand the edges flat so that the
body sections can be installed.
53
Now install the body panels from parts 52 to
54.
Updated June 2016
52
53
54
Page 10
Then fit the cockpit. To do this, you will need
parts 211, 212 and 213.
211
213
211
First stick on the rear wall, part 212. Then stick
on the sides parts 211 and finally, from be-
neath, the floor 213.
Next, install the bushings for the sheet ropes.
At this point, you have to decide what type of
steering you want for your headsail.
-
The simple version, variant 1, allows
you to control it with a simple 4-
channel system. With a sheet rope for
foresail and jib in the middle of the
boat. This requires a headsail with just
one winch.
Or, you can go for the slightly more
-
elaborate, but original, version, variant
2, with one sheet rope each for the
port and starboard side. Here, 2
winches are required for the headsail,
one on the port and one on the star-
©
Krick Modelltechnik Knittlingen
212
Publicité
