Bosch CM8S Consignes D'utilisation/De Sécurité page 43

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 43
▶ Crown Molding Auxiliary Fence
the table, narrow cut-off pieces (2" or less in
width) may be propelled at high speed over the
fence and beyond the back of the tool (see figure
50). Use auxiliary fence as instructed and shown
in figures below.
▼ MAKING CROWN MOLDING AUxILIARY
FENCE:
▼ FIRST-TIME USE OF THE AUxILIARY FENCE:
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
Saw Operations
When making a compound
cut on a molding lying flat on
Be aware of the path of the
saw blade. Make a dry run
FIG. 50
FIG. 51
Auxiliary
Fence
43
Small Cut-off
Piece
Auxiliary
Fence
Small Cut-off
Piece