Bosch CM8S Consignes D'utilisation/De Sécurité page 40

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 40
▶ Crown Molding Angled to Table and
Fence
FIG. 46
Crown Molding
Angled Against
Fence
Optional
Crown Stop
Follow these instructions for cutting crown
molding angled to table and fence:
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
Saw Operations
Bottom
Edge of
Molding
45° Miter
Be aware of the path of the
saw blade. Make a dry run
▼ MITER AND BEVEL SETTINGS FOR STANDARD
CROWN MOLDING CUTS
(When Workpiece Angled Against Fence)
Assumptions:
Ceiling
52°
Wall
38°
38/52° Crown Molding
38° Spring Angle
Inside
Corner
Refer to Chart
Cutting – Angled to Table and Fence
Fence
40
Ceiling
45°
45° Wall
45/45° Crown Molding
45° Spring Angle
Outside
Corner
"
Bottom Edge
Molding Placed
Upside Down
Crown Stop
Table