Bosch CM8S Consignes D'utilisation/De Sécurité page 41

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 41
▶ Crown Molding Lying Flat on Table
FIG. 47
Crown
Molding Flat
on Table
Follow these instructions for cutting crown
molding lying flat on table:
operation. Before switching "ON," lower head
assembly to make sure clamp clears guard and
head assembly.
with the saw Off by conducting a simulated
cutting cycle, and observe the projected path of
the saw blade. Keep hands at least six (6) inches
away from the projected path of the saw blade.
Saw Operations
Bevel Setting
Miter Setting
Use clamping position that
does not interfere with
Be aware of the path of the
saw blade. Make a dry run
▼ MITER AND BEVEL SETTINGS FOR STANDARD
CROWN MOLDING CUTS
(With Molding Flat on Table) Assumptions:
Ceiling
52°
Wall
38°
38/52° Crown Molding
38° Spring Angle
Inside
Corner
Fence
41
Ceiling
45°
45° Wall
45/45° Crown Molding
45° Spring Angle
Outside
Corner
Top of Molding
Against Fence
Table