3 INSTALLATION
3.6 Electrical wiring 8020 with adjustable pulse output 4
Unscrew central screw and remove the cover. Pull cable through PG 9 and wire according
to following pin assignment. The connection to a PLC or any other device with frequency
input is identical to the connection of the single sensor with Hall effect output
1: output PNP
2: L-
3: output NPN
4: L+ (12...30 VDC)
Fig. 3.9 Electrical wiring type 8021
3.7 Electrical wiring 8020
with 4...20 mA output 5 (type 8023)
Loosen central screw and take off the cover. Run the cable through the PG9 cable gland
and wire up in accordance with the following pin assignment:
1: L+(12...24 VDC)
2: L-
See Appendix for connection examples.
Fig. 3.10 Electrical wiring type 8023
!
Warning: polarity inversion may damage the device
FLOW SENSOR TYPE 8020
E-12-
8020