Electrical Wiring; Safety Instructions; Technical Data Of The Cables For The Female Connectors, Type 2508 Or Type 2509 - Burkert 8220 Manuel D'utilisation

→
Install the fitting (mark 5) on the pipe acc. to the
Operating Instructions of the fitting used and
acc. to the Fig. 4.
→
Check that the seal (mark 6) is on the conduc-
tivity sensor.
→
Insert the nut (mark 3) on the fitting.
→
Insert the snap ring (mark 2) in the groove
(mark 4).
→
With a cell constant K=10, point the opening
of the channel (see Fig. 2 chap. 6.3) in the
direction of the fluid.
→
Slowly push the device in the fitting. If the
mounting is correctly done the device cannot
be turned around anymore.
→
Hand thighten the nut to lock the assembly.
Fig. 5: Installation of the 8220 on the S020 fitting
14
6
English
7.3

electrical wiring

7.3.1

safety instructions

danger
1
risk of injury due to electrical discharge
▶ Shut down the electrical power source of all the conductors and
isolate it before carrying out work on the system.
2
▶ Observe all applicable accident protection and safety regula-
3
tions for electrical equipment.
4
• Use a filtered and stable power supply.
5
• Do not install the cable near high voltage or high frequency
cables. If this cannot be avoided, observe a min. distance
of 30 cm.
7.3.2 Technical data of the cables for the
female connectors, type 2508 or
type 2509
Cable technical data
Electromagnetic protection
(EMC)
Maximal length
Diameter
Operating temperature
Type 8220
Installationandwiring
Recommended
shielded
10 m
5...8 mm
minimum 80 °C