Intended Use; Basic Safety Information - Burkert 8220 Manuel D'utilisation

Intendeduse
2

inTenDeD use

use of the device that does not comply with the instructions
could present risks to people, nearby installations and the
environment.
the 8220 conductivity sensor is intended solely for the meas-
urement of the conductivity of liquids.
▶ This device must be used in compliance with the characteristics
and commissioning and use conditions specified in the contrac-
tual documents and in the Operating Instructions.
▶ This device must be protected against electromagnetic interfer-
ence, ultraviolet rays and, when installed outdoors, the effects of
climatic conditions.
▶ Only use a device which is in correct operating condition.
▶ Store, transport, install and use the device properly.
▶ Only use the device as intended.
existing restraints
Observe any existing restraints when the device is exported.
Type 8220
3

bAsic sAfeTy informATion

This safety information does not take into account:
• any contingencies or occurences that may arise during installation,
use and maintenance.
• the local safety regulations for which the operating company is
responsible including the staff in charge of installation.
Danger due to electrical voltage
▶ Shut down the electrical power source of all the conductors and
isolate it before carrying out work on the system.
▶ Observe all applicable accident protection and safety regula-
tions for electrical equipment.
risk of injury due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to high fluid temperatures.
▶ Use safety gloves to handle the device.
▶ Stop the circulation of fluid and drain the pipe before loosening
the process connections.
risk of injury due to the nature of the fluid.
▶ Respect the prevailing regulations on accident prevention and
safety relating to the use of hazardous products.
English
5