Water Counter Screen; Default Setting Reset Screen; Alarm Signals; Faulty Counter Screen - La San Marco TOP 85 Emploi Et Entretien

10.15 Water counter screen

Screen 43
WATER FLOW METER

10.16 Default setting reset screen

Screen 29
RESET TO FACTORY
SETTINGS
NO
Screen 30
FACTORY RESET
DONE

11. Alarm signals

11.1 faulty counter screen

Screen 31
ALARM FLOW METER

11.2 Water softener filter replacement screen

Screen 32
CHANGE WATER
SOFTENER FILTER
Screen 33
WATER SOFTENER
RESET
Water counter technical level programming screen.
This technical level programming screen is used to inform the machine
if the water volume counter has been installed at the machine inlet.
The - button displays a flashing NO and the + button a flashing yES.
Pressing the Ok button confirms the change and the value will again
be fixed.
Default setting: NO
If no button is selected within 30 seconds, the machine ready screen
will appear automatically (screen 17).
Pressing ESC returns to the machine ready screen (screen 17).
Default setting reset screen.
This screen is used to delete all the set parameters and restore the
default settings.
Use the  /  buttons to switch between NO and yES
If yES is selected, press Ok for at least 5 seconds to confirm the
reset, screen 30 will appear on the display.
Press NEXT to go to the next screen (no. 17) and resume the se-
quence of the technical level programming screens.
Pressing ESC returns to the machine ready screen (screen 2).
Default setting reset completed screen.
This screen indicates that the default settings have been reset.
Pressing ESC returns to the machine ready screen (screen 2).
Counter faulty signalling screen.
This screen signals that there is a malfunction of one of the ma-
chine's impulse counters.
The group with the malfunction is indicated.
Water softener filter replacement signalling screen.
This screen indicates that the machine's water softener filter must be
replaced and appears when the value set on screen 28 is reached
or exceeded.
This screen will not be displayed if the water counter was not enabled
on screen 43.
The warning is shown for 5 seconds after each brewing operation,
but does not block the possibility of brewing coffee.
To reset the signal and make the relative counter restart from 0, press
the + / - buttons at the same time for at least 2 seconds.
Once the counter is reset, screen 33 is displayed.
Water softener filter replacement signal reset screen.
This screen signals that the water softener filter replacement alarm
was reset.
This screen will not be displayed if the water counter was not ena-
bled on screen 43.
Pressing ESC returns to the machine ready screen (screen 2).
63