Drawing Steam; Hot Water Outlet - La San Marco TOP 85 Emploi Et Entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

After applying the filter holder cup to the unit, press one of the five buttons for the unit to be used:
Short programmed single dose
Long programmed single dose
Short programmed double dose
Long programmed double dose
Manual continuous dose
Programmed dose brewing
The LED relative to the button of the preselected dose will flash while the coffee is brewing. The other buttons
will remain lit with a fixed light. When brewing is complete, the light on the selected button will again be fixed.
Press the selected button again if you want to stop the programmed brewing before the dose has been reached.
Brewing coffee in START-STOP mode
By pressing one of the continuous dose buttons, the LED for the selected button will flash while the coffee is
brewing. The other buttons will remain on with a fixed light during the brewing cycle.
To stop the continuous brewing, STOP the dose by pressing the selected button again.
Brewing in continuous mode is stopped automatically (if not stopped manually) when the maximum product
quantity of approx. 0.5 litres is reached.
Note:
The dosing makes it possible to brew coffee in all units at the same time.
Each group has a push-button dispensing with five buttons (four for the programmed doses and one for
manual doses. On display also is a bar graph that simulates (filling) the amount of coffee when making coffee.

6.2 Drawing steam

A jet of steam, which can be used to foam milk or to heat other liquids, comes out of the steam drawing spout
as follows: by raising or lowering the lever you attain the maximum flow (the lever stops in the maximum posi-
tion. To stop the flow of steam, place the lever back in its original position).
The steamer must be used with care: the contact of the skin with the steam spout or with the jet
of steam itself can cause serious burns. Grip the anti-burn sheath to change the position of the
steam drawing spout. Never aim the jet of steam at persons or at objects which do not have to
do with the use as described in this manual.
Note:
Before using the spout for drawing steam, drain out into the tub any condensation which may have formed in
it. After using the spout, clean it properly with a moist cloth, and if necessary discharge any residue remaining
inside it into the tray.

6.3 hot water outlet

Use the hot water keypad 8 to collect hot water from the boiler for tea, chamomile, etc.
The keypad has three keys (two for the programmed doses and one for manual doses). While the water
comes out, the display shows a light bar that simulates (by filling up) the hot water doses; the display also
shows the seconds required for the operation.
52

Publicité

Table des Matières
loading

Table des Matières