Setting Up The Compressed-Air Motor En - Abicor Binzel BRS-CC Mode D'emploi

BRS-CC
6.8 Setting up the compressed-air motor
1 Clamping device
2 Gas nozzle
Fig. 11 Setting up the compressed-air motor
 Fig. 6 on page EN-13
1 Loosen the compressed-air motor from the guide block (4) by removing the screws (3).
2 Pull back the compressed-air motor (5) in its fastener.
3 Place the required distance sleeve (7) on the reamer (6).
4 Move the torch with the gas nozzle (2) to the clamping position (P2).
5 Keep the guide block (4) in the lower position (lift down).
6 Place the compressed-air motor (5) against the gas nozzle (2) with the distance sleeve placed
on top (7).
7 Fasten the adjusted motor position by means of the screws (3).
8 Move the torch out the clamping device (1) and remove the distance sleeve (7) from the
reamer (6).
NOTE
• Make sure that only clean and dry compressed air is used.
1
7
6
5
3 Screws
4 Guide block
The compressed air must correspond at least to the quality class 4 according to ISO 8573-1.
2
3
4
5 Compressed-air motor
6 Reamer
6 Putting into operation
7 Distance sleeve
EN - 17