Bartscher VAK 100 300741 Mode D'emploi page 41

•
Do not use the accessories and spare parts not recommended by the producer. They
may be dangerous for the user or damage the vacuum packing machine and cause
injuries of people, and will also invalidate the warranty.
•
Before using the device read this operation manual and keep it for future use.
•
The vacuum packing machine is not designed for continuous operation. Therefore it
is required to assure at least 1 minute between the successive cycles.
•
Intensive operation of the vacuum packing machine may activate the automatic
thermal switch. It is then required to leave the vacuum packing machine until cooling
down for at least 20 minutes so the thermal switch may deactivate.
•
Do not use the vacuum packing machine near or on hot surfaces.
•
The vacuum packing machine housing is not protected from the liquid penetration.
Avoid suction of liquids into the vacuum chamber. In such situation the chamber
must be immediately dried.
•
Do not immerse the vacuum packing machine in water and do not use it when the
supply cable or socket are wet. In such situation during the operation put on the
rubber gloves and immediately remove the plug from the socket. Do not remove
or touch the vacuum packing machine immersed in water before the plug is
removed from the socket. After removing from water do not use the device
(make it tested by the authorized service company or professional shop).
•
Do not touch the sealing strip during the vacuum packing machine operation.
Burn hazard!
•
After use always remove the plug from the socket.
•
Never open or modify the vacuum packing machine. The maintenance and repairs
must be performed only by the professional technicians with use of original spare
parts and accessories. Never attempt to repair the device by yourself.
The unauthorized repairs will invalidate the warranty.
•
Do not use broken or damaged vacuum covers and containers!
- 37 -