General Information; Symbol Used; Safety Instructions; Correct Usage - Burkert 1094 Standard Instructions De Service

1 GENERAL INFORMATION

1.1 Symbol used

The following symbols are used in these operation instructions:
marks a working step that you must carry out.
ATTENTION!
NOTE

1.2 Safety instructions

To ensure that the device functions correctly and will have a long service life, please
comply with the information in these operating instructions as well as the operating
conditions and the permissible ranges that are specified in the data sheet.
• When planning the application and the operation of the device, observe the gen-
eral technical rules!
• The device may not be used in areas endangered by explosion with the character-
istics of Zones 0 or 1.
• Take suitable measures to exclude any unintentional operation or impermissible
impairment!
• Installation and maintenance work may only be carried out by specialists and with
suitable tools!
• Observe the valid regulations for the prevention of accidents and for the safety of
electrical devices during the operation and maintenance of the device!
• Always switch of the electrical power before carrying out any work on the system!
• Only use the device in its original configuration!
• If these instructions are ignored or if impermissible interventions are made to the
device, no liability will be accepted from our side, and the guarantee on the device
and its accessories will also become invalid!

1.3 Correct usage

This device is only intended for the electronic control of a proportional valve for va-
pour recovery on fuel pumps. Any other use, or any use going beyond this will be con-
sidered to be improper usage. Bürkert will thereby accept no liability for any resulting
damage. The risk will be borne by the user alone.
Indicates information that must be followed. Failure to do this could
endanger your health or the functionality of the device
Indicates important additional information, tips and recommen-
dations.
1094 - 3