Getting Started; 1: Unpacking; Inserting Batteries Into The Remote - Sony HT-K250 Mode D'emploi

Getting Started

1: Unpacking

Check that the following items are supplied:
• Control center (1)
• Subwoofer (1)
• Micro satellite speakers (5)
• Control center stand and a screw (1 each)
• Remote commander (1)
• R6 (size AA) batteries (2)
• Speaker cords (long) (2)
• Speaker cords (short) (3)
• System cord (1)
• Optical digital cord (1)
• FM wire antenna (1)
• AM loop antenna (1)
• Speaker foot pads (20)
• Speaker sticker (1)
• Speaker adaptor for wall use and a screw (5
each)
• This Operating Instructions (1)
• Speaker installation guide (1)
Inserting batteries into the
remote
Insert two R6 (size AA) batteries with the + and
– properly oriented in the battery compartment.
Tip
Under normal conditions, the batteries should last for
about 6 months. When the remote no longer operates
the control center, replace both batteries with new
ones.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
GB
4
• Do not expose the remote sensor of the control center
to direct sunlight or lighting apparatuses. Doing so
may cause a malfunction.
• If you do not use the remote for an extended period
of time, remove the batteries to avoid possible
damage from battery leakage and corrosion.
• Turn off the power to all components before making
any connections.
• Be sure to make connections firmly to avoid hum and
noise.