Getting Started; Unpacking; Inserting Batteries Into The Remote - Sony DAV-FR10W Mode D'emploi

Getting Started

Unpacking

Check that you have the following items:
• Speakers (5)
• Subwoofer (1)
a)
• IR transmitter (1)
a) b)
• IR receiver (1)
b)
• IR receiver stand (1)
• AM loop antenna (aerial) (1)
• FM wire antenna (aerial) (1)
• Speaker cords (3.5m × 3, 10m × 1) (12ft. × 3,
34ft. × 1)
• Video cord (1)
• Remote Commander (remote) RM-SP350 (1)
• Size AAA (R03) batteries (2)
• Operating Instructions
• Speakers - Connection and Installation (card)
(1)
a)
The cords of the IR transmitter and IR receiver are
for this system only. You cannot use a
commercially available extension cord.
b)
Used when the IR receiver of the surround speaker
(L) cannot receive infrared ray because of the
position. For details, see "Using the IR receiver"
(page 30).
Inserting Batteries into
the Remote
You can control the system using the supplied
remote. Insert two size AAA (R03) batteries by
matching the 3 and # ends on the batteries to
the markings inside the compartment. When
using the remote, point it at the remote sensor
on the system.
Remove the cover.
Notes
• Do not leave the remote in an extremely hot or humid
place.
• Do not use a new battery with an old one.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct light from
the sun or lighting apparatus. Doing so may cause a
malfunction.
• If you do not use the remote for an extended period of
time, remove the batteries to avoid possible damage
from battery leakage and corrosion.
13 US