Step 3: Tv And Video Component Hookups - Sony DAV-FR10W Mode D'emploi

Step 3: TV and Video Component Hookups

Required cords
Video cord for connecting a TV
Audio cords (not supplied)
When connecting a cord, be sure to match the color-coded sleeves to the appropriate jacks on the
components.
Terminals for connecting video components
Connect the
TV (VIDEO IN)
VCR (AUDIO OUT)
Digital satellite receiver
(AUDIO OUT)
Notes
• The video signal is output as below:
– When [COMPONENT OUT] is set to [INTERLACE] in [SCREEN SETUP] (page 85) (default)
The video signal is output from the S VIDEO and VIDEO jacks of MONITOR OUT.
– When [COMPONENT OUT] is set to [PROGRESSIVE] in [SCREEN SETUP] (page 85)
The video signal is output from the COMPONENT VIDEO OUT jacks only.
• When you connect a VCR or digital satellite receiver to the VIDEO/SAT jacks of this system, change the function
to VIDEO or SAT (page 76).
Tips
• When using the S video jack instead of the video jacks, your TV monitor must also be connected via an S video
jack. S video signals are on a separate bus from the video signals and will not be output through the video jacks.
• When using the COMPONENT VIDEO OUT jacks (Y, P
must also be connected via COMPONENT VIDEO OUT jacks (Y,P
format signals, you must use this connection and set [COMPONENT OUT] to [PROGRESSIVE] in [SCREEN
SETUP] (page 85).
To the
MONITOR OUT (VIDEO) jack
VIDEO (AUDIO IN) jacks
SAT (AUDIO IN) jacks
/C
B B
Yellow
White (L/audio)
Red (R/audio)
, P /C ) instead of the video jacks, your TV monitor
R R
/C , P /C ). If your TV accepts progressive
B B R R
continued
23 US