Sony DAV-FR10W Mode D'emploi page 90

Adjusting the speaker
balance and level by using the
test tone
1
Press DVD SETUP in stop mode.
The Setup Display appears.
2
Press X/x repeatedly to select
[SPEAKER SETUP], then press ENTER
or c.
3
Press X/x repeatedly to select [TEST
TONE], then press ENTER or c.
4
Press X/x repeatedly to select [ON],
then press ENTER.
You will hear the test tone from each
speaker in sequence.
5
From your listening position, adjust the
value of [BALANCE] and [LEVEL] using
C/X/x/c.
When selecting [BALANCE], the test tone
is emitted from both left and right speakers
simultaneously.
When selecting [LEVEL], the test tone is
emitted from only the speaker which you
are adjusting.
6
Press ENTER when you have finished
making adjustments.
7
Press X/x repeatedly to select [TEST
TONE], then press ENTER.
8
Press X/x repeatedly to select [OFF],
then press ENTER.
Notes
• When you adjust the speaker settings, the sound cuts
off for a moment.
• The surround back speaker level can be also adjusted
on the amplifier that is connected to the surround
back speaker.
Tip
To adjust the balance or the level without listening to
the test tone, select [BALANCE] or [LEVEL] in step 3
and press ENTER. Then adjust the balance or level
using X/x and press ENTER.
US
90
Setting the speakers by using
the front panel display on the
system
You can set the speakers by using the AMP
menu that is displayed in the front panel display.
AMP menu list
SP SETUP
CENTER SP CENTER Y
CENTER N
SURR Y
SURR SP
SURR N
a)
SURR B N
SURR B SP
SURR B Y
F DIST 1.0 m - 7.0 m/3 ft to 23 ft
b)
CEN DIST 1.0 m - 7.0 m/3 ft to 23 ft
b)
SURR DIST 1.0 m - 7.0 m/3 ft to 23 ft
b)
SB DIST 1.0 m - 7.0 m/3 ft to 23 ft
b)
SP POS SP BEHIND
SP SIDE
LEVEL
TESTTONE T.TONE OFF
T.TONE ON
F BALANCE 6 steps left or right
b)
–6 dB - +6 dB
CEN LEVEL
b)
–6 dB - +6 dB
SL LEVEL
b)
SR LEVEL –6 dB - +6 dB
b)
SB LEVEL –10 dB - +10 dB
SW LEVEL –6 dB - +6 dB
AUDIO DRC DRC OFF
DRC ON
a)
This setting appears when you set "SURR SP"
to "SURR Y" in "SP SETUP."
b)
This setting appears when you set the
corresponding speaker to "Y" in "SP SETUP."