Automatic Tuning; Presetting Radio Stations; Tuning To Preset Stations - Sony HT-K250 Mode D'emploi

frequency seems to be higher than the entered value,
press TUNING +, and if the frequency seems to be
lower than the entered value, press TUNING –.
• If "STEREO" flashes in the display and the FM
stereo reception is poor, press FM MODE to select
"MONO". You will not be able to enjoy the stereo
effect, but the sound will be less distorted.
Note
If "STEREO" does not appear at all when an FM
broadcast is received normally, press FM MODE to
turn on the "STEREO" indication.

Automatic tuning

If you don't know the frequency of the station
you want, you can let the receiver scan all
available stations in your area.
1
Press TUNER.
You can also use INPUT SELECTOR on
the control center.
2
Press TUNER repeatedly to select FM
or AM band.
3
Press TUNING + or TUNING –.
Press TUNING + to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
4
To continue scanning, press TUNING +
or TUNING – again.
If the FM stereo reception is poor
Press FM MODE to select monaural mode.
If "STEREO" flashes in the display and the FM
stereo reception is poor, the sound will be less
distorted in the monaural mode.

Presetting radio stations

Up to 30 FM or AM stations can be preset.
You can tune in any of the stations you preset
directly.
Presetting radio stations
1
Press TUNER.
You can also use INPUT SELECTOR on
the control center.
2
Tune in the station that you want to
preset using Manual Tuning (page 18)
or Automatic Tuning (page 19).
3
Press MEMORY.
The ALT button lights up.
"MEMORY" appears in the display for a
few seconds. Do step 4 before it goes out.
4
Press SHIFT to select the memory page
(A, B or C) and press numeric buttons
to select a preset number.
The station is stored to the preset number.
If "MEMORY" goes out before you press
the preset number, start again from step 3.
5
Repeat steps 2 to 4 to preset another
station.

Tuning to preset stations

On the control center
1
Press VOL/PRESET TUNING.
The preset number flashes.
2
Turn VOL/PRESET TUNING to select the
preset number.
Each time you turn VOL/PRESET TUNING,
the receiver tunes in one preset station at a
time, in the corresponding order and direction
as follows:
tA1yA2y...yA0yB1yB2y...yB0T
tC0y...yC2yC1T
continued
GB
19