Sony HT-K250 Mode D'emploi page 12

To avoid short-circuiting the
speakers
Short-circuiting may damage the speakers and
cause a malfunction.
Make sure the stripped ends of each
speaker cord does not touch the stripped
end of another speaker cord.
Examples of poor conditions of the speaker
cord
Stabilizing speakers
To prevent speaker vibration or movement while
listening, attach the supplied foot pads at the
bottom of the speakers. If you are using the
speaker stand (not supplied), you do not need to
attach them.
Using speaker stand (not
supplied)
When using separately sold speaker stand
(WS-FV10D, WS-WV10D), you can easily
configure your speaker layout.
WS-FV10D
GB
12
Installing the satellite
speakers on the wall
Fasten the screws (not supplied) to the wall. The
screws should protrude by 5 to 6 mm.
Attach the speaker adaptor for wall use
(supplied) with the screw (supplied), then hang
the satellite speakers on the screws.
Notes
• Use the screws that matches the wall material and
strength.
• Install the satellite speakers on a vertical and flat wall
where reinforcement is applied. Do not install the
satellite speakers if the wall is not vertical, flat or
strong enough.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony will refrain from any responsibility on the
accident or damage caused by improper installation,
lack of durability of the wall or screws improper
operation, natural calamity, etc.
WS-WV10D
(Wall use)
5 to 6 mm
speaker adaptor for wall use
4.2 mm
9.2 mm