Assembly - Batavus CR5 Mode D'emploi

•
.The.equipment.has.been.designed.for.
home.use..The.Batavus.warranty.applies.
only.to.defects.and.malfunctions.in.home.
use.(24.months)..Further.information.on.
warranty.terms.can.be.obtained.from.
your.national.Batavus.distributor..Please.
note.that.the.warranty.terms.may.vary.
from.one.country.to.another..Please.
note.also.that.the.warranty.does.not.
cover.any.damage.caused.by.failure.to.
observe.the.installation,.adjustment.or.
maintenance.instructions.included.in.this.
owner's.manual.
•
.Do.not.attempt.any.servicing.or.
adjustments.other.than.those.described.
in.this.guide..Everything.else.must.
be.left.to.someone.familiar.with.the.
maintenance.of.electromechanical.
equipments.and.authorised.under.the.
laws.of.the.country.in.question.to.carry.
out.maintenance.and.repair.work.
SAVE tHIS INStRUCtION MANUAL

ASSEMBLY

Start by unpacking the equipment. Two people are
needed for the assembly. Assembly kit (contents
marked with * in the spare part list): keep the
assembly tools, as you may need them e.g. for
adjusting the equipment If necessary, please
contact your dealer with the model, equipment
serial no. and spare part no. of the missing part.
You'll find a spare part list at the back of this guide.
The packaging includes a silicate bag for absorbing
moisture during storage and transportation.
Please dispose of the bag once you have unpacked
the equipment. The directions left, right, front
and back are defined as seen from the exercising
position. Allow at least 100 cm of clearance around
the equipment. We also recommend opening
the package and assembling the product on a
protective base.
REAR AND FRONt SUPPORt
Mount the rear foot tube to the base frame using
the screws, the washers and the cap nuts. Mount
the front foot tube to the base frame in the same
way. Make sure that the rollers for the foot caps
face forward and down during assembly
PEDALS
Screw the pedals into the threads of the crank
arms. Screw the left pedal (marked L for left-hand
thread) into the left crank arms. Use the wrench
and rotate it counterclockwise. Screw the right
pedal (marked R for right-hand thread) tightly
clockwise into the right crank arm. Now attach the
pedal straps to the pedals.
SEAt HANDLEBAR
Attach the seat handlebar to the seat frame with six
mounting screws and washers. Connect the cable
from the handlebar to the cable coming from the
seat frame. Caution: Do not pinch the cable!
O W N E R ' S M A N U A L
G B
3