Indicators On The Charging Station And Troubleshooting; Indicators On The Robot Lawn Mower And Troubleshooting - EINHELL FREELEXO BT Instructions D'origine

Masquer les pouces Voir aussi pour FREELEXO BT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 52

11. Indicators on the charging station and troubleshooting

LED indicator (21)
Off
Lit up green
Flashing green
Lit up red

12. Indicators on the robot lawn mower and troubleshooting

The alarm LED (53) is lit up red
Fault
"Robot lawn mower
has lifted".
"Robot lawn mower
is stuck"
The robot lawn
mower has come
to a stop near an
obstacle.
Anl_FREELEXO_BT_SPK13.indb 44
Anl_FREELEXO_BT_SPK13.indb 44
GB
Description
- No power supply
- Ready for mowing
- Rechargeable battery is fully
charged
- Perimeter wire (18) is cor-
rectly installed
- Perimeter wire (18) is se-
vered
- Perimeter wire (18) is not
properly connected
- Rechargeable battery is
charging
Possible cause
- The lifting sensor has been
continually tripped for 10 se-
conds
- The obstruction sensor has
tripped 10 times within one
minute
- 44 -
Solution
- Check the power supply
- Inspect the perimeter wire (18) for a break
- Check the two connections on the char-
ging station (19)
- Wait until the rechargeable battery is fully
charged.
Remedy
Press the "OK" button (54) to reset the error.
Re-start the mowing operation on the control
panel (2).
- If this fault occurs frequently, check the
mowing area for obstacles taller than 10
cm and either remove them or cordon
them off from the mowing area with peri-
meter wire (18).
Press the "OK" button (54) to reset the error.
Re-start the mowing operation on the control
panel (2).
- Check whether the robot lawn mower
is blocked by an obstacle or jammed
between trees, bushes, etc. Remove the
obstacle or avoid this area.
- If this fault occurs frequently, check the
way in which the perimeter wire (18) has
been laid. Pay particular attention to tight
angles, corridors, fences, rocks, etc., and
adjust the layout of the perimeter wire (18)
if necessary.
- Check whether the grass is too tall and
the robot lawn mower gets blocked. If this
is the case, mow the grass to below 60
mm.
22.09.2021 10:12:12
22.09.2021 10:12:12

Publicité

Table des Matières
loading

Table des Matières