EINHELL FREELEXO BT Instructions D'origine page 47

The alarm LED (53) fl ashes blue
Fault
"Robot lawn mower
is tilted"
The robot lawn
mower has toppled
over and come to
a stop.
"Mower is stuck"
The robot lawn mo-
wer comes to a stop
on the way back to
the charging station.
Troubleshooting
Fault
The robot lawn mo-
wer comes to a stop
in the mowing area.
The robot lawn
mower cannot be
switched on:
The robot lawn
mower cannot move
into the charging
station.
The robot lawn mo-
wer stops or travels
out of control when
near perimeter is-
lands.
Anl_FREELEXO_BT_SPK13.indb 47 Anl_FREELEXO_BT_SPK13.indb 47
GB
Possible cause
- The robot lawn mower was
constantly tilted for 10 se-
conds
- The robot lawn mower has
been tilted for a prolonged
time in one direction
- The movement of the robot
lawn mower is blocked by
an obstacle on the perimeter
wire (18)
Possible cause
- Battery voltage too low
- Fault in the power circuit or
the electronic components
- The charging station (19) is
not installed correctly.
- The perimeter wire (18) has
not been installed correctly
around the perimeter islands.
- 47 -
Remedy
Press the "OK" button (54) to reset the error.
Re-start the mowing operation on the control
panel (2).
- Move the robot lawn mower to a level area
and restart it.
- If the robot lawn mower is tilted because
of a steep slope in the mowing area, ad-
just the perimeter wire (18) accordingly to
avoid severe inclines.
Switch off the main switch (7) (OFF) and
place the robot lawn mower at a diff erent
point in the mowing area. Switch on the main
switch (7) again (ON) and restart the mo-
wing operation on the control panel (2).
- Remove all obstacles on the perimeter
wire (18).
Remedy
- Bring the robot lawn mower back to the
charging station (19) for charging.
- Switch on the main switch (7) (ON).
- Contact your customer service center.
- Make sure that the LED indicator (21) on
the charging station (19) is lit up green.
- Make sure that the perimeter wires (18)
are connected at the charging station (19)
and that the front perimeter wire (18) is
laid in the middle underneath the charging
station (19).
- Make sure that the charging station (19) is
positioned correctly.
- Adjust the position of the perimeter wire
(18).
- Make sure that the perimeter wire (18)
does not cross over itself
22.09.2021 10:12:13 22.09.2021 10:12:13