Inogen ONE G3 Mode D'emploi page 20

4. Check the device display screen to confirm that an external power supply is connected.
An icon of a battery with a lightning bolt or an AC power plug will be displayed on the
screen, indicating that external power is connected and functioning properly.
WARNING Ensure that the automobile power socket is adequately fused for the Inogen
One® G3 power requirements (minimum 15 Amp). If the power socket cannot
C
!
support a 15 Amp load, the fuse may blow or the socket may be damaged.
WARNING The tip of the Cigarette Adapter Plug becomes HOT when in use. Do not touch
C
!
the tip immediately after removal from an auto cigarette lighter socket.
CAUTION Ensure the automobile power socket is clean of cigarette ash and the adapter
plug fits properly, otherwise overheating may occur.
CAUTION Do not use the power supply with a cigarette plug splitter or with an
extension cable. This may cause overheating of the DC power input cable.
CAUTION Do not jump start the automobile with the DC power cable connected.
This may lead to voltage spikes which could shut down and/or damage the
DC power input cable.
CAUTION When powering the Inogen One® G3 in an automobile ensure the vehicle's
engine is running first, before connecting DC cable into cigarette lighter adapter.
Operating the device without the engine running may drain the vehicle's battery.
CAUTION A change in altitude (for example, from sea level to mountains) may affect total
oxygen available to the patient. Consult your physician before traveling to
higher or lower altitudes to determine if your flow settings should be changed.
Traveling By Air
The FAA allows the Inogen One® G3 onboard all U.S. aircraft, here are a few points to make air
travel easy.
Planning Your Flight
When flying with the Inogen One® G3, you must inform the airline that you will be using your
Inogen One® G3 onboard the aircraft. You must also keep a signed statement from your
physician with you that includes:
16