Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi page 78

Installation instructions, only for experts
6. Mains connection for light and electronics
These connections must be used for the 3-pole mains connection (supply cable
for light and electronics).
7. Connection of a cabin light
These connections must only be used for 230 V~ (< 100 W) filament lamps.
Contact an available earth wire with the collective terminals 5.4.9.
CAUTION!
Feed the cable through the construction screw joint provided for.
8. Neutral wire collective connection (N)
CAUTION:
Without this supply, the controller will not operate.
Light N- neutral wire
Light L- phase
N
N
N
CAUTION!
These connections are connected to one another
on the conductor plate (collective terminal). .
p. 36/42