Sentiotec wave.com4 Instructions De Montage Et Mode D'emploi page 67

Instructions for use for the user
You have the option of correcting the temperature value displayed. This is pos-
sible within a range of ±9°C. Proceed as follows to do so:
Change to the
9
the and keys 2 times. This enables you to access the temperature set-
5 6
tings menu.
The symbol flashes when the
at least 3 seconds. Then press and hold the
selection.
TIP!
A temperature rectification value of "0" is set as standard.
Your value inputted here corresponds to Δt in the graphic below.
Figure 10: temperature rectification
(thermometer symbol) with the
and
5
Measured temperature
Showed temperature
symbol. Press and hold
7
keys are pressed simultaneously for
6
and
7 4
p. 25/42
akeys to confirm your
EN