Throttle Cable Installation; Throttle Cable Connection To Rocker Arm - Ultraflex B110B Manuel D'installation Et D'entretien

ULTRAFLEX

3.7 Throttle cable installation

The instructions for connecting the throttle cable are provided below.
1 Rotate the lever at least 45° to bring
the slide in the lower part of the rocker
arm to insert the pin (see picture).
Insert pin (I) in the outer hole of the
slide from the lower part of therocker
arm towards the upper (see picture)
and lock it by means of circlip (O).
O
I

3.7.1 Throttle cable connection to rocker arm

Screw cable and fitting (H) on the thread
1
of the throttle cable.
H
CAUTION
- The correct operation of the control depends on the exact adjustment of the throttle stroke.
page 18
of 67 -
SINGLE LEVER CONTROL B110
Secure casing fastener block (K) to the mechanism by
2
means of the casing fastener bush (J), washer (N) and screw
(M). Insert the cable in the casing fastener (K), making sure it
is turned outwards, as indicated in the picture. Stop it by
inserting the elastic split pin (L) into the center seat.
J
K
N
M
Insert the cable and fitting on pin (I) and
2
secure it by means of circlip (O).
I
O
Installation and maintenace manual
L
K