Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
2 INSTALLATION
2.1 Necessary tools
14 mm hexagon wrench
Cross slot screwdriver
2.2 A96 Installation
1
Install the cylinder by carrying out the instruc-
tions indicated in the manual and positioning the
engines as shown in the pictures indicated in point 2.
NOTE
Do not assemble the plugs on the cylinder body
(see the picture aside).
If the plugs are already mounted, it is necessary
to remove them.
2
Position the engines in the center of the stroke
observing any convergence or divergence recom-
mended by the engine manufacturers as shown in
the picture aside (see the pictures below).
NOTE
With the same distance between centers of the en-
gines, the "L" length of the bar will vary according
to the chosen convergence or divergence angle.
page 8
of 47
- TIE BAR A96
22 mm hexagon wrench
L2
Installation and Maintenance Manual
2x
Loctite® 270
Dynamometric wrench
4mm hex key
L1
L3
Publicité
Chapitres
Table des Matières
