Minimum Transom Requirements; Necessary Tools - Ultraflex INTEGRA UC120 Serie Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Minimum transom requirements

The following picture shows the minimum splash well dimensions. These dimensions must be respected in
order to prevent the cylinder from being damaged when the outboard engine is completely tilted upwards. The
picture shows also the minimum transom dimensions, needed for the installation and the correct operation of
the engine steering cylinder.
Engine No.
1
2
NOTICE
In case of configurations with three or four engines it is necessary to check the dimensions of the transom and
the relative cockpit before starting the installation phase.
WARNING
ENGINE JACK PLATE APPLICATION TO THE TRANSOM.
A jack plate installation will change all the application clearances. A new clearance check must be completed with
the tilting of the engine in conjunction with the vertical movement of the jack plate in all the possible positions.
If the steering cylinder comes into contact with the splash well, transom and/or jack plate, stop the installation
immediately! Use the jack plate manufacturer's instructions to limit the upper or lower direction in which the
interference occurs. If this is not possible please contact specialized staff.

3.2 Necessary tools

Open end
wrench
9/16"
Allen wrench
[1/8"]
page 14
of 71 -
HYDRAULIC CYLINDERS FOR OUTBOARD ENGINES
MINIMUM SPLASH WELL DIMENSION REQUIREMENTS MINIMUM SPLASH WELL DIMENSION REQUIREMENTS
A
576 mm - 22.68"
1152 mm - 45.35"
Open end Open end
wrench wrench
16 mm 3/4"
Torque wrench
Installation and Maintenance Manual
C
B
305 mm - 12"
305 mm - 12"
Open end
wrench
11/16"
MOLYKOTE® 1000
A
C
152 mm - 5.98"
152 mm - 5.98"
Drill
Hole saw
Ø 25 mm - 1"
Cross slot screwdriver