Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ULTRAFLEX
WARNING
When setting the convergence or divergence
angle, follow the instructions given by the
engine manufacturer, by imposing in any
case and in any direction a total angle of no
more than 5° and the difference between the
measurements "A" (measurement of the dis-
tance between centers of the engines on the
boat) and "B" (distance between the propeller
shafts) of less than 1" (25.4mm) (see picture).
WARNING
Follow the engine adjustment procedure
exactly.
3
Adjust the length of the bar by screwing and unscrewing the two ball joints (1) of the same size according
to the distance between centers L1 of the engines.
DISTANCE BETWEEN
CENTERS OF THE ENGINES
NOTE
It is possible to have a maximum extension of 38mm (1.5") for each part with respect to A96-29; and an ex-
tension of 70 mm (2.75") with respect to A96-34.5.
WARNING
DO NOT FORCE THE UNSCREWING OF THE BAR'S END WHEN REACHING THE MAXIMUM EXTENSION.
DANGER
FORCING THE UNSCREWING OF THE BAR'S END WILL IRRETRIEVABLY DAMAGE THE BAR.
NOTE
Be careful not to damage the exposed thread: dents on the thread cause seizure of the parts.
NOTE
The correlation of the distance between centers is L2 or L3 and the bar length depends on the chosen diver-
gence or convergence angle.
APPROXIMATE LENGTH OF THE BAR L
26''
27''
28''
29''
30''
31''
32''
33''
34''
34.5''
1
Installation and Maintenance Manual
558 mm (22'')
585 mm (23'')
610 mm (24'')
635 mm (25'')
660 mm (26'')
685 mm (27'')
710 mm (28'')
735 mm (29'')
760 mm (30'')
775 mm (30.5'')
L
TIE BAR A96
page 9
-
of 47
Publicité
Chapitres
Table des Matières
