Necessary Tools; Cylinder Installation - Ultraflex UC 378 Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Necessary tools

Open end
wrench
22 mm (0,86")

3.2 Cylinder installation

DANGER
An arm (1) shorter than the one indicated could move the helm instead of the cylinder up to the end stroke
by causing the breaking of the steering guide and the following loss of boat control.
WARNING
A longer arm (1) reduces the steering angle.
NOTICE
If the arm is not already mounted, see the mounting instructions of the arm manufacturer.
NOTICE
If the arm corresponds to the dimensions shown in the picture, follow the assembly drawing below,
otherwise follow the indications on the following page.
y
228 mm [8,97 in.]
A
1
l
page 10
of 64 -
HYDRAULIC CYLINDER FOR INBOARD ENGINE
Open end
wrench
24 mm (0,94")
B
Installation and Maintenance Manual
Torque wrench