Tools Required; Control Box Installation; Adjustment Of The Lever Inclination (Except Chtl/Bhtl Version Not Included) - Ultraflex B 501 Manuel D'installation Et D'entretien

ULTRAFLEX
3 INSTALLATION

3.1 Tools required

Phillips
screwdriver

3.2 Control box installation

1 Install the control in a position that allows the lever to rotate free and take care that it can reach the
full forward and full reverse stroke.
2 Refer to the overall dimensions given in paragraph 1.2 to check that the box can effectively be
installed in the desired position.
WARNING
When the cable is installed avoid too narrow bends.
3 After determining the appropriate location, drill the holes required to assemble the control box
using the template provided for single or dual control.
NOTICE
Connect the cables to the lever before the lever control to the dashboard.
CAUTION
The use of a proper killing switch system is recommended for each ULTRAFLEX control system installation.
3.3 Adjustment of the lever inclination
(Except CHTL/BHTL version not included)
The lever angular position can be adjusted both forward and backward according to the control position.
Follow the instructions below:
1 Remove the hub
plug of the lever (1).
3 Extract the lever
and turn it to the
desired position, then
reinsert it by putting
into gear with the shaft
of the control box.
page 8
of 63 -
SINGLE LEVER CONTROL B501 AND B502
Pliers
2 Take
hexagonal
screw (2) with a 17
socket wrench.
1 1
4 Apply threadlocking low
strength (Loctite 222) on the
screw
completely.
Insert the hub plug by paying
attention to position the plug cut
upward as shown in the picture.
Installation and maintenance manual
Open end
wrench
8mm [0,31"]
out the
head
(2) and fasten
Socket wrench
17mm [0,66"]
2
it