Trim Electrical Connections - Ultraflex B 501 Manuel D'installation Et D'entretien

ULTRAFLEX

3.9 Trim electrical connections

Carry out the electrical connections of the cables coming from
the lever following the diagrams shown below depending on
the used engine.
The lever cables will be marked by a little flag "UP" and "DOWN"
for the trim controls and "GND" for the earth.
WARNING
Before fixing the cables definitively, check that the lever can move freely in all positions.
NOTICE
The following diagram is only a guideline for the most common engines.
For a specific detail of the wiring refer to the manuals of your boat.
TRIM UP
NEUTRAL
TRIM DOWN
TILT switch necessity
WARNING
The circuit diagram for MERCURY, MERCRUISER and MARINER requires the use of Mercury solenoid kit and
conductor complex.
CAUTION
In case of high inductive load, we recommend to use a supporting relay in order to protect the switch.
CAUTION
In case of dual engine both solenoid valves are actuated by a single switch. In this case a suitable relay is
required for the proper operation of the system.
page 14
of 63 -
SINGLE LEVER CONTROL B501 AND B502
P B/O
Pk/R
R P B with W line
G G/O
Bl
YES YES NO
Installation and maintenance manual
G
Y Bl
P P R
Bl
G G
YES YES NO
G Green
R Red
B Black
W White
P Purple
O Orange
Pk Pink
Bl Blue
Y Yellow