Installation Of The Neutral Safety Switch - Ultraflex B 501 Manuel D'installation Et D'entretien

ULTRAFLEX

3.8 Installation of the neutral safety switch

This optional device allows starting the engine only with the shift in neutral position, avoiding unexepected
movements of the boat.
To assemble it do as follows:
1 Put the lever
forward until the holes
on the plate (27) can
be seen through the
slot on the plate (26).
3 Through the slot located on
the plate (28), insert the screw (33)
in the switch hole through the hole
of the plate (29).
Insert the nut (34) from the outer
side of the plate (29) and tighten
the screw (33).
NOTICE
If you are installing the switch X12, the screw and the nut must be inserted inside the hole (A). For the switch
X43, the reference hole is (B).
Installation and maintenance manual
2 Position
device (30) on plate
(29) inserting the
cylinder (31) inside
the plastic guide
(32).
31
30
27
26
33
28
SINGLE LEVER CONTROL B501 AND B502
the
32
29
29
34
A
B
page 13
-
28
of 63