Safety Warnings; Clothing - Ultraflex B 501 Manuel D'installation Et D'entretien

ULTRAFLEX

5 SAFETY WARNINGS

This section illustrates the safety regulations to be applied for proper use of the apparatus.
Read this section very carefully and also read the manuals supplied with other components of the single
lever control.
5.1 Safety warnings during installation and use
OBLIGATORY FOLLOW the precautions and safety criteria indicated below.
ULTRAFLEX shall not be held liable for the user's failure to observe these precautions and criteria and shall
not be held liable for any negligence in use of the system.
DANGER
- NEVER PUT HANDS BETWEEN THE MOVING PARTS.
- Do not deactivate safety devices or render them inoperative.
- Do not modify the system or add devices to it without written authorization or the intervention of an
ULTRAFLEX technician describing the change made in the description of the work performed.
- Do not use the apparatus for any purpose other than its intended purpose as specified in the installation
and maintenance manual.
- Do not allow untrained personnel to perform installation.
WARNING
- During installation of the system, take particular care to keep everything clean to ensure that no
foreign bodies can get into the system. Even a tiny object can cause permanent damage which may
not be immediately obvious.
- Avoid cable curve radiuses of < 200 mm (8").
- Do not let cables come into contact with sharp corners or edges.
- Do not let cables come into contact with heat sources.

5.2 Clothing

WARNING
DO NOT wear necklaces, bracelets or any loose garments that could get caught in moving parts during
ATTENZIONE
installation, inspection or maintenance work.
page 16
of 63 -
SINGLE LEVER CONTROL B501 AND B502
Installation and maintenance manual
!