Lever Without Kill Switch Model - Ultraflex B110B Manuel D'installation Et D'entretien

ULTRAFLEX

3.2.1 Lever without kill switch model

CAUTION
Avoid bending the cables too narrowly (minimum radius: 200 mm - 8"). The use of ULTRAFLEX cables is
recommended.
Refer to the dimensions indicated in paragraph 1.2 to verify that the control can actually be
1
installed in the chosen position.
After having established the appropriate
2
location, drill the necessary holes to insert the
mechanism with the help of the appropriate
template (supplied). The thickness of the lever
installation surface must not exceed 20mm
(0.7").
Fasten mecheanism (A) to flange (A1) by
4
means of screws (G).
A1
G
A
Installation and maintenance manual
Fasten the flange
3
gasket (A2) by means of screws (F).
A2
A1
F
NOTICE
Then, connect the throttle cable and the shift cable
to the frame and the rocker arm, as indicated in
paragraphs 3.6 and 3.7.
SINGLE LEVER CONTROL B110
(A1) and its
F
page 11
- of 67