Broncolor Scoro Serie Mode D'emploi page 8

IMPORTANT SAFETY INSTRUCTIONS
Do not touch the connection socket for mains cable and lamp outlets on the power pack and do not
>
poke in them with metal objects!
Flash tubes, halogen modelling lamps and protecting glasses heat up to a high operating tem-
>
perature, this also applies to the front side of the lamps! Therefore the attachments also assume
high temperatures! Handle with care! Contact with hot components can cause injuries!
Do not come into contact with glass or metal whilst operating the flash light system!
>
Let the unit and its connected lamp base cool completely after use and before packing!
>
Always unplug appliance from electrical socket before cleaning and servicing and when not in use!
>
Never jerk cable to pull the plug from the socket. Grasp plug and pull to disconnect!
Dropped or damaged units or lamps must be checked by a specialist before reconnection!
>
To reduce the risk of electric shock, never open the power pack or lamps! Dangerous voltages
>
could still remain inside the unit even after it has been disconnected from the mains supply. There-
fore, take the unit to an authorised broncolor service station when service or repair work is required.
Incorrect reassembly can cause electric shock, even when the unit is closed.
Shipping instructions Scoro:
Use original broncolor packing for the transport of the power pack!
>
Shipping instructions lamps:
Use original broncolor packing for the transport of the lamps. Before shipping flash tubes, halo-
>
gen lamp and protecting glass pack them with our protective packing material (foam plastic and
transport cap). If the protective packaging is incomplete, remove flash tube, halogen lamp and
protecting glass from the lamp and send them separately!
8