Lcd Display And Menu System - Broncolor Scoro Serie Mode D'emploi

2. LCD DISPLAY AND MENU SYSTEM

It has never been so easy to activate that many settings with so few keys; thanks to the LCD
display. The display is a significant tool, and therefore it is important that, firstly, you become well
acquainted with the structure of the menu system.
The brightness of the user interface can be automatically or manually* dimmed dependent on the
ambient light. See LCD setting function "Brightness display" (section 13.19).
2.1 LCD display menu system
Directly after switching on the unit a start display appears for approximately 5 s with information
about the unit and the owner. Afterwards the unit changes automatically to the normal operat-
ing mode. By default, the flash duration (t 0.1) is shown permanently. In addition, depending on
whether the flash duration or the colour temperature have been altered*, the display will adjust
and the current value will be indicated.
Scoro E shows additionally the performance in joules of the connected lampheads.
When delay (dly), sequence (seq), interval (int), alternate (alt) are activated as well as the studio
and unit address (if desired), the corresponding functions will be shown on the main page. The
functions shown in the display give an overview of the most important activated additional func-
tions of the power pack*.
The main menu is called up with the key "menu" (22). At the same time, at the bottom edge of the
display, a user guide appears, showing the selection keys (21 & 22) each with their supplementary
functions ("
q/p
"menu" (22). Each set value is displayed in a box at the top of the LCD.
10 * Scoro S only
", "+/–", "select", "cancel", "quit", "help"). To return to normal mode, press the key