Broncolor Scoro Serie Mode D'emploi page 7

Protect the flash light equipment from electromagnetic fields, shock and vibration!
>
Protect the flash light equipment from heat and frost! If the power pack freezes continuous
>
loss of power output and serious technical damage can result!
> Sudden temperature differences can cause condensation water in the unit! In such situations
the equipment must stay for 1 hour in a well ventilated place to acclimatise to the new tem-
perature before start up!
Do not operate the units in an environment where there is a risk of explosion!
>
The power pack should not be operated in or near water! Attention: high voltage!
>
The power pack and the lamps should not be immersed in water or other liquids!
>
It could cause an electric shock!
Remove the transport protection cap on the front side of the lamp before connecting it to the
>
power pack!
For safety reasons, never operate the lamp base without the protecting glass in place! UV-
>
coated protecting glasses or UV-coated flash tubes must be utilised as a protection against UV
radiation for eyes and skin!
Before operation the lamp has to be fastened on a stand or a suspension device!
>
The lamp must be locked by tightening the mounting screw!
Only sand-filled fuses of the type indicated on the safety type plate may be used! Sand-filled
>
fuses can be identified by their opaque fuse body! With incorrect fuse protection the halogen
lamp may burst!
Filters or diffusers should not be fastened directly on the flash tube, halogen modelling lamp
>
or protecting glass!
Do not operate appliance with a damaged earthed cable. Cables which are damaged or twisted
>
must be replaced!
The unit must only be connected to an earthed socket, or an emergency power generator!
>
If an extension cable is necessary, a cable with a current rating at least equal to that of the
>
appliance should be used. Cables rated for less amperage than the appliance may overheat.
When using a cable reel, it must be completely unrolled before use to prevent overheating of
the cable!
The unit is suitable for operation with a motor generator provided that the voltage lies within
>
all the load conditions (including capacitive load) and within the tolerance limit of 200 – 264 V
or 95 – 135 V! From experience this means that only electronic stabilised motor generators are
to be utilised! When operating on unstabilised motor generators, voltage peaks of 300 V and
more have been observed! This can lead to damages for which we assume no liability!
Do not operate the lamps inside a bag or a box!
>
The ventilation slots on the unit or on the lamp should not be covered!
>
Pay attention when laying, clearing away or rolling up cables that they do not contact hot sur-
>
faces or parts of lamps and that they will not be tripped over by persons!
7