Release - Broncolor Scoro Serie Mode D'emploi

6. RELEASE

6.1 RFS 2 Interface (Radio Frequency System)
Scoro power packs are supplied with built-in RFS 2 radio release. The antenna is not visible as
it is integrated into the handle. RFS 2 can be switched on or off with the key "ir / rf" (14). A flash
control is activated via RFS 2 and IR by default. The definition of the IR / RFS key is entered in
the LCD display under the position "Flash control" (section 13.13). The following settings are
possible: IR / -, - / RFS 2, IR / RFS 2. Switching off the RFS 2, simultaneously deactivates all the RFS 2
functions from the camera transmitter.
For RFS 2 flash control, the channel (studio address) must correspond with the Transceiver's RFS 2
channel. The channel (studio address) is defined in the LCD display under "studio address"
(section 13.15).The lamp (lamp address) is defined in the LCD display under "lamp address"
(section 13.15).
With the RFS 2 Transceiver you can define and adjust the individual lamp outlets on the flash
units as you wish. To make these adjustments, please follow the procedure given in the operating
instructions for the RFS 2 Transceiver.
The RFS 2 Transceiver is not included in the power pack's scope of supply.
6.2 "test" key
This key (16) allows manual release of the power pack. Flash release is possible as soon as 70 %
of the set energy is available.
The visual ready signal (16), however, lights up only when 100 % is available.
6.3 Photocell (cell)
The photocell can be switched on or off using the "cell" key (13). If it is activated, the blue LED next
to the key lights up. After the first flash of a sequence, the active photocell will be deactivated and
the blue info LED next to the "cell" key (13) blinks. By pressing the "cell" key it is reactivated.
6.4 Sync socket
The synchronous cables art. no. 34.111.00 and 34.112.00 may be plugged into the sync socket (4)
to trigger flashes via cable.
6.5 Flash triggering via infrared receiver (ir)*
The IR receiver can be switched on or off with the key "ir / rf" (14). If the function is activated, the
blue LED next to the key lights up. A flash release is activated via RFS and IR by default. The
definition of the IR / RF key is entered in the LCD display under "Flash control"(section 13.13). The
following settings are possible: IR / -, - / RFS, IR / RFS.
Scoro power packs may be triggered by broncolor infrared transmitters. If the power pack is trig-
gered via infrared, the flash release follows with a minimal time delay of approximately 0.8 msec.
6.6 Servor*
All broncolor infrared remote controls (servor) can cause inadvertent flash triggering. In this case,
switch off the "IR" function (see section 13.13).
16 * Scoro S only