Memory Functions; Easy Mode - Broncolor Scoro Serie Mode D'emploi

9.3 Memory functions*

In standard and user mode, there are four memories each. All the
unit settings can be stored therein (see LCD function "memory 1 – 4"
section 13.20). Selecting one of the four memories redirects to an in-
formation window in the LCD, in which the most important data of the
corresponding memory are indicated. Pressing the "recall" key reini-
tializes the data in the memory. Pressing the "store" key overwrites
the memory contents with the latest unit settings.
Those functions, which are stored in standard or user mode, are
shown in the two columns "mem" (memory) and "Standard / User" in
chapter 13.
9.4 Freemask / Alternate release*
With the Freemask function of Scoro S it is possible to generate a freemask. For this purpose
two power packs are released asynchronously, for the background and the object to be isolated
(section 13.8).
Alternate release enables to realise even faster shooting sequences. Alternate release also enables
shorter sequences, up to four times faster, even with higher energy (see LCD function "Alternate",
section 13.9). With the same function it is possible to reduce the interval of stroboscopic sequences
down to a minimum of 0.01 s (section 13.6).

9.5 Easy mode*

You can minimize the operating display due turn on the easy mode. Please read the following
instructions:
Press the "user" key (18) for 5 s. The menu skips to the program setting "easy mode".
>
Activate or deactivate the easy mode by pressing "on" respectively "off".
>
> Turn off and turn on the unit. The easy mode is now activated.
9.6 "reset" key Scoro S
> Brief pressure on the "reset" key (19) advances the cursor directly to the main page. When press-
ing the "menu" key (22) the cursor returns to the beginning of the main menu.
Pressing this key for approximately 2 s resets the flash additional functions. This is confirmed by
>
a double-beep tone.
Pressing this key for approximately 10 s resets all the functions to the factory settings. This is
>
confirmed by a double-beep tone.
9.7 Reset Scoro E
Press the "test" key (16) for 4 s. The unit will reset all the functions to the factory settings.
9.8 Submenu Scoro E
To reach the submenu of the Scoro E please press the "menu" key (22) for 4 s. The correspondent
functions will be more explained in chapter 14.
20 * Scoro S only