Broncolor Scoro Serie Mode D'emploi page 28

14. SCORO E
ADDITIONAL FUNCTIONS & LISTING IN LCD MAIN MENU
Section Function
14.0 WiFi
14.1 Modelling light
14.2 Sequence (seq)
14.3 t 0.1 (flash duration)
14.4 Charge time
14.5 Studio setup
14.6 Audio ready signal
14.7 Volume key sound
14.8 Serial number
14.9 Program version
14.10 Country
14.11 Delivery date
14.12 Language
28
Description of function
WiFi settings
Choice of the modelling light level. See section 5.1.
Allows to define a flash series or the pre-selection of a defined
number of flashes to be triggered together with the shortest
possible intervals; provided that the "interval" function is not
activated. After the flash series has been triggered, the photo-
cell becomes deactivated. To prevent overheating after extended
flash series (to protect the flash tubes), the unit will automa-
tically shut off.
Choice of flash duration t 0.1. The setting range is dependent on
the selected power.
Choice of charging time slow / fast.
"Slow" for longer charging times as option for weak power grids
and motor generators.
To determine studio address or RFS 2 channel.
The same channel must be set at the RFS 2 transmitter.
To determine lamp address (1 / 2 / 3). The same lamp address
must be set at the RFS 2 transmitter.
Studio display: Studio and lamp addresses can be displayed on
the main page of the LCD display.
An acoustic ready signal sounds when the power capacitors are
100 % charged. The volume of the signal can be defined.
Setting of acoustic tone.
Individual serial number of the unit. Keep available in case of
servicing / repair.
Current program version. Can be updated by our service
department.
Static country code for specific service data.
Distributors delivery date.
To simplify operation, you can choose between various languages.
In numeric English the figures of the functions correspond to the
LCD menu of the sub-sections of section 11.
For example: "23 flash sequence" corresponds to the LCD menu
from section 13.22 of the operating instructions.