Protective Facilities; Circuit Breaker; Lamp Compatibility; Service / Repair - Broncolor Scoro Serie Mode D'emploi

10. PROTECTIVE FACILITIES

10.1 Cooling
The cooling fan switches to a higher speed for a certain time after a few flashes.
10.2 Thermal overheating display
To protect against overheating after extended flash series, the unit will automatically switch off.
At that stage, the following message will appear on the LCD display: "alarm: thermo" and the ap-
proximate time required for cooling. The cooling time is shortened if the unit remains connected
and switched on.

10.3 Circuit breaker

In the event of an electrical malfunction, the circuit breaker (2) will automatically disconnect the
power pack from the power source. The unit can be restarted by pressing the circuit breaker button.
If it disconnects again immediately the power pack must be serviced by an authorised service station.

11. LAMP COMPATIBILITY

Almost all broncolor lamps are electrically compatible with the Scoro power packs. The most
popular lamps, such as the Pulso and Unilite range, as well as Ringflash (C & P) may be used with
the Scoro without any limitations. Particularly for the small lamps, there are thermal limitations
which must be taken into consideration when using them with the Scoro power pack (see corre-
sponding max J / min specifications on the lamps).
For a detailed compatibility list please visit our website www.broncolor.swiss -> Support -> Down-
loads -> Compatibility Charts
12. SERVICE | REPAIR
Your broncolor power pack is a precision device which will work for many years without malfunc-
tion if you take proper care of it. If nevertheless malfunctions do arise, please do not attempt to
open the unit to repair it yourself. Even when the unit is switched off, dangerous voltages may
remain within the interior of the device. Therefore, always let our broncolor service station carry
out repairs or service work.
21