Thermador Professional PODS301W Mode D'emploi page 44

en-us Cleaning and maintenance
Insert the tip of a narrow flat-blade screwdriver between
5.
the metal clips at about a 40° angle.
The screwdriver blade must be able to pass between
the metal clips to reach the inner catch.
Push the screwdriver blade inward to disengage the
6.
catch from the slot in the bulb housing. Gently pry the
lens off by moving the screwdriver handle away from
the oven wall.
Support the glass lense cover with both hands to pre-
7.
vent the cover from falling to the bottom of the oven.
The lens should detach easily. Do not attempt to force
it.
44
Remove the bulb by grasping and sliding the bulb
8.
straight back until the two prongs have cleared the ce-
ramic holder.
DO NOT touch the glass of the new replacement bulb
9.
with your fingers. It may cause the bulb to fail when it
first lights. Grasp the replacement bulb with a clean dry
cloth. Locate the two prongs in the ceramic holder, gen-
tly poking until the two prongs locate in the ceramic
socket.
Press down to seat the bulb.
10.
Put the glass lense cover back on by inserting it into the
11.
mounting clip and pressing the end nearest you into the
housing until it locks into place. Insert the screw through
the glass lense cover and tighten.
Reinstall the oven rails.
12.
Turn on the circuit breaker.
13.
Recalibrating the steam oven
The steam oven automatically calibrates to adjust to the
pressure conditions in your area the first time steam is
used at 212°F (100°C). If you should move, you can re-
calibrate the steam oven manually to ensure that it auto-
matically adjusts to your new location. Recalibration is not
necessary after a power failure.
Requirement: The oven cavity is cool.
Fill the water tank.
1.
Remove the accessories from the steam oven cavity.
2.
Wipe the smooth surfaces in the oven cavity with a soft,
3.
wet cloth.
Set the heating mode and temperature.
4.