Speck pumpen BADU Jet active Notice D'installation page 51

12. - Model SPOT with underwater fl oodlight *
This model - in contrast to the basic unit - has additional
- Extended housing
- Separately included isolating transformer 12 V, 300 VA / 12 V A.C. 50 VA
- Built-in underwater fl oodlight with 300 W, 173 mm dia. / 50 W, 100 mm dia.
- Junction box with isolating transformer terminal
The isolating transformer which has been tested in accordance with VDE 0551
or EN 60742, respectively, comes with a potted 2 m power cord. It has a ther-
mal overload switch as well as short-circuit protection and has a potted cable
of 10 m length on the secondary side. The transformer itself is watertight when
sprinkled with a hose.
The 300 W lights have been tested according to DIN VDE 0711 Part 1 and/or
EN 60598-2-18, respectively. Existing safety regulations demand that a
temperature sensing switch be provided inside the light housing. During
prolonged operation of the 300 W light it may switch off automatically and - after
having cooled off - come on again automatically.
These lights are operated at 12 V and are therefore harmless.
Before replacing a defective light bulb the entire unit must be pulled out of the
pool.
Electrical Connection
1. The isolation transformer must be installed outside the protected zone (at least
3.5 m away from the pool edge). An ON/OFF switch for the light must be
provided at the installation site.
2. The light cable is pre-assembled inside the junction box of the isolation
transformer and is joined with the bipolar cable of the isolation transformer at
the terminals.
3. The underwater light should only be operated under water.
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd
* ) Not available
with BADU Jet
active!
For electrical
circuit diagram for
the fl oodlight see
page 17 fi g. 12
It is imperative that
the fl oodlight is
submerged before
switching it on.
Use above water
level will cause
damage.
50