Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. - Filling the Unit and Start-up
6.1.1
With BADU Jet impulse, click the massage hose onto the nozzle of the
unit, then push a hose (e.g. garden hose) into the nozzle of the massage
hose. Cover the remaining opening with your hand.
Open air drain valve* on the pump and fi ll unit with water through the
garden hose. Make sure that the unit is well aerated. As soon as water
seeps out of the air drain valve, close valve and remove garden hose
and massage hose.
6.1.2
With BADU Jet Standard, insert water hose (e.g. garden hose) into the
nozzle of the unit and cover the remaining opening with your hand. Open
air drain valve on the pump and fi ll unit with water. Be sure that the unit
is suffi ciently aerated. As soon as water seeps out of the air drain valve,
shut valve and remove water hose.
6.1.3
With BADU Jet swing and BADU Jet action, unscrew the red fi ller plug
and fi ll unit by means of a water hose or a watering can (approx. 20
liters). Once the pump is fi lled put red plug back in place and tighten
carefully by hand. The pump will now prime.
6.2
Press position switch (n° 27 in the spare-parts fi gure) and briefl y switch
unit ON and OFF with push button in order to check the direction of
rotation of the motor. Note the directional arrow on the pump. In case of
incorrect direction of rotation, switch 2 phases.*
6.3
Put cover back into position and tighten. When assembling, mind the
position switch!**
6.4
After verifying that all pertinent rules and regulations have been
observed, start unit by means of push button.
6.5
Filling up of the BADU Jet active Version 2
The air in the pump is removed and replaced with water using the
vacuum hose and the pump of the fi lter installation.
This is done as follows:
After having secured the BADU Jet onto the edge of the pool.
ATTENTION: For the priming/aeration to be effective the air regulation
knob MUST be closed.
6.5.1
Fill the vacuum cleaner hose with water by pushing it in the water verti-
cally. Then place one end onto the nozzle of the counter current unit and
place the other end, making sure the hose is still fi lled with water, on the
skimvac in the skimmer.
6.5.2
Turn on the fi lter pump. The fi lter pump will now suck in water through
the jet unit hereby drawing out the air that is trapped in it and replacing it
with water. As the air from the jet unit reaches the fi lter pump there may
be a momentary drop in the fl ow through the fi lter pump. Remove the
vacuum hose from the skimvac and keep the end of the hose under
water. Wait a short while until the fi lter pump has re-primed. Place the
hose back on the skimvac again and repeat this process as often as is
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd
Once the unit is
fi lled it will prime
by itself after a
short time. If this
is not the case,
please repeat the
fi lling as described
under point 6.
*) Only necessary
for 400 V 50 Hz
3 ~ models
**) Tighten the
screws only by
hand. Do not use
force!
46
Publicité
Table des Matières
