Speck pumpen BADU Jet active Notice D'installation page 45

2.8 Unauthorized modes of operation
The reliability of the machine delivered will be only guaranteed if it is used in
the manner intended, in accordance with clause 1 - General of this manual.
The limit values specifi ed in the data sheet must under no circumstances be
exceeded.
Cited Standards/Norms and other Documentation
DIN 4844 Part 1
Supplement 13
DIN 4844 Part 1
Supplement 14
3. - Transportation and Intermediate Storage
To avoid any damaging of the unit or loss of any loose part the original packaging
should not be opened until arrival on its installation site.
Prolonged intermediate storage in an environment of high humidity and fl uctuat-
ing temperatures must be avoided. Moisture condensation may damage windings
and metal parts. Non-compliance will void any warranty.
4. - Description
The BADU Jet countercurrent unit can be used with any type of pool.
A high-output jet pump is connected to the fi berglass housing via a suction and
pressure pipe. The housing is attached on the edge of the pool. Water is sucked
in by the jet pump at low velocity via inlets on the housing and then injected into
the pool under high pressure via the nozzle.
The activation and de-activation of the jet pump is controlled by a pressure
switch, installed on the housing.
The power of the fl ow can be regulated by means of the adjustable nozzle*. Air
can be added to the water jet through the air-intake.
Safety marking; Safety symbol W 8
Safety marking; Safety symbol W 9
09.05.2007 TB-b BTA_einhaengeanlagen_v2_engl.indd
On units used for
outdoor pools the
original packaging
can be used for
winterizing.
Therefore do not
dispose of the
packaging. When
winter arrives drain
the unit, put it in
its packaging and
store in a dry place
for the duration of
the winter.
Optional accesso-
ries include: atta-
chable massage
nozzle, massage
hose, massage
hose with pulsator,
and an attachable
pulsator
*) not applicable
for BADU Jet
active and
BADU Jet
standard
44