Rectifying Errors - Bosch GRL 600 CHV Notice Originale

54 | English

Rectifying errors

Rotary laser display Laser re-
indicator ceiver dis-
play indic-
ator
–
–
−/PNK
–
–
–
–
ERR
ERR
–
ERR
1 609 92A 6AE | (28.05.2021)
Problem Corrective measure
Automatic shut-down Change the rechargeable or non-rechargeable battery as
(empty rechargeable/non- necessary.
rechargeable battery)
Automatic shut-down (op- Adjust the measuring tool to the ambient temperature
erating temperature ex- before switching it on. Then check the measuring accur-
ceeded) acy and calibrate the measuring tool if required.
Unsuccessful attempt to Briefly press the on/off button (11) to close the error
connect to the remote message. Start the connection process again (see "Es-
control (40) or the laser tablishing a connection to the remote control/laser re-
receiver (41) ceiver", page 41).
If it is not possible to establish a connection, please con-
tact a Bosch customer service agent.
Unsuccessful attempt to Briefly press the on/off button (11) to close the error
connect to the mobile message. Start the connection process again (see "Re-
device
mote control via Bosch Levelling Remote App",
page 42).
If it is not possible to establish a connection, please con-
tact a Bosch customer service agent.
Measuring tool is at a slant Reposition the measuring tool so that it is in either the
of more than 8.5 % or is not horizontal or vertical position. The re-levelling will start
in the correct horizontal or automatically.
vertical position.
Maximum levelling time is Reposition the measuring tool so that it is in either the
exceeded horizontal or vertical position. Briefly press the on/off
button (11) to restart levelling.
Change between the hori- Briefly press the on/off button (11) to restart levelling.
zontal and vertical position
without switching the meas-
uring tool on/off
Unsuccessful calibration of Cancel the calibration with
the X-axis line operation (5).
Ensure that the receiving field of the laser receiver is per-
pendicular to the corresponding axis (X/Y) of the measur-
ing tool. Restart the calibration.
Unsuccessful calibration of
the Y-axis
Unsuccessful calibration of Cancel the calibration with
the Z-axis line operation (5). Check that the measuring tool is
aligned correctly and restart calibration.
Unsuccessful CenterFind Press any button to close the error message.
Check whether the measuring tool and laser receiver
mode in relation to the X-
have been set up correctly. The laser receiver must be
axis
situated within the pivoting range of ±8.5 % of the meas-
uring tool.
Restart the mode.
by pressing the button for
by pressing the button for
Bosch Power Tools