Led Functions; Replacing The Battery - FLAEM Aspira go P1611EM-20 Mode D'emploi

2.1. Vehicle power outlet cable (12V DC) (20):
2.1.1. Using the vehicle power outlet cable (20), connect the external device socket (18) to the vehicle power
outlet. Check the battery charge status of the vehicle or boat before connecting the power outlet cable.
2.1.2. Switch the device on by acting on the switch (2); the operation is displayed by the activation of the green
LED (1a). The device is designed for an intermittent use of 30 min ON/30 min OFF.
2.2. Multi-voltage power supply (switching) (19).
2.2.1. Connect the connector of the device to the external socket (18) of the device. Insert the power cord into
the electrical outlet that corresponds to the voltage of the appliance, and then remove the plug from the power
outlet at the end of the appliance. The position of the socket must be such that the device can be easily un-
plugged from the mains network. In the event that the power cable plug is unsuitable for the mains socket,
contact the dealer or an authorised service centre.
2.2.2. Repeat the instructions in section 2.1.2
2.3. Charging the internal battery using the vehicle power outlet cable or multi-voltage power supply:
Check the battery charge status of the vehicle or boat before connecting the power outlet cable.
2.3.1. The battery is charged by leaving the vehicle power outlet cable or the multi-voltage power supply (19)
connected to the external device socket (18). The activation of the green LED (1a) and of the yellow LED (1b)
indicate that the internal battery is charging.
Charge the device for 24 hours the first time it is used; subsequently 7 hours (minimum) are sufficient to charge
model P1611EM-20 and 4 hours (minimum) for model P1611EM-30.

LED FUNCTIONS

1a 1b 1c

REPLACING THE BATTERY

To replace the battery, follow the instructions on page 1. Release, lift and remove the lid of the battery compartment
located at the back of the device (dwg.1,2,3); remove the battery to be replaced and insert the new one, fitting the
connector properly (dwg.4,4a); put the battery compartment lid back in place and close it (dwg.5,6). Then charge the
battery following the instructions in section 2.3.1.
Flat batteries must be disposed of in special waste collection containers, or by contacting a suitable waste disposal
centre.
It is forbidden to use batteries other than those provided with the medical device. If necessary contact an authorised
FLAEM service centre.
GREEN LED (1a): when it is switched on it means that the external power supply is
connected (12VDC), i.e. the switching power supply has been inserted in the device
socket (18).
YELLOW LED (1b): when it is switched on it means that the battery is charging while
when it is switched off it means that the battery is charged and ready for use*.
Only for model P1611EM-30: of the YELLOW LED (1b) flashes is means that the bat-
tery is not connected and/or is not connected to the circuit properly
(see dwg. 4, 4a, 4b).
RED LED (1c): flashing and acoustic alarm active, both mean that the battery is about
to run out and must be charged as soon as possible.
*IMPORTANT: to charge the battery insert the power supply plug (12VDC) into the
device socket (18).
13